M30 x 1.0 HSS Tap Set Volkel
Volkel M30 x 1.0 HSS-G Serial Tap Set
Serial taps comprise of one or more undersized roughing taps which remove most of the material before final sizing with a finishing tap.
Some reasons for using serial taps are:
The roughness of the material being tapped.
The amount of material to be removed could cause swarf choking with a single tap.
The very small tolerance on pitch diameter.
An extremely good finish required.
Made in Germany
Din2181 HSS-G, Tolerance ISO2/6H
Overall Length 90mm
Flute Length 22mm
Shank Diameter 22mm
Square 18mm
Application :
For General UseNon abrasive material up to 900 N/mm²
Unalloyed and low alloyed steel
Suitable for tapping through and blind holes
For tapping by hand
Part Number 26528
Product Unit | Set |
---|---|
Product Width | 0.0000 |
Product Height | 0.0000 |
Product Length | 0.0000 |
Manufacturer | Volkel |
Unit of Measure | inches |
Validate your login